The control lock on bottom right is solid red.
Maytag washing machine door locked blinking.
Wait approximately 2 minutes for control to reset.
Answered by a verified appliance technician we use cookies to give you the best possible experience on our website.
Water remaining in washer after cycle.
When attempting this make sure power is off to the washer and use extreme caution.
If f8 e1 or lf too long to fill appears in the display the washer is taking too long to fill or the washer is filling and draining.
You could have a failed control console or a bad electronic control board in the washer.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Is the door locked and the add a garment light off.
The washer door will unlock at the end of the drain.
Nothing else will appear to be happening with the machine during this time.
The door remains locked during this time.
If the control locked light will not turn off i recommend unplugging the washer for 5 minutes.
1 year old it s a 4 3 cu ft.
Select drain spin to remove any water remaining in the washer.
Looking at your use and care guide page 31 trouble shooting i have held read more.
It is flashing red door locked.
This is a guide about unlocking the door on a maytag front load washer.
Is water hooked up to the washer and turned on.
Was the washer turned on before being connected to water.
My maytag front load washer has a blinking door locked and the door will not open up.
When using one of these cycles the door will remain locked until the cancel button is pushed.
Did you just install.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
This can reset the washer and clear the flashing lid lock light.
The door may immediately unlock.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
Does the drain pump run constantly.
Reconnect power to washer plug in.
Maytag front load washer door will not open.
The lid lock flashing reasons causes and repair solutions are for most whirlpool kitchenaid maytag amana and kenmore top loading washing machines.
Fresh hold option is on.
If not i recommend calling a service technician to diagnose and repair the washer.
The door should unlock after 60 seconds.
Is the door locked and the add a garment light on.
Plug the unit back in and see if the controls will respond.
Run a drain and spin cycle.
It s possible the drain hose extends more than 4 5 114 mm into the standpipe.
The washer will go into a hold and drain routine for 8 minutes.
I have a control lock on my front load washer.
