Maytag Washer Lid Lock

W10240513 washer lid latch lock strike replace part p4514459 ps2579805 ap6017583 replacement for whirlpool kenmore amana maytag roper sears 4 4 out of 5 stars 46 7 99 7.

Maytag washer lid lock.

The washer will drain after 10 minutes if the lid remains open. Some models have lights on the console which show when the lid is locked. Jump the lock at the lid switch to stay open. Quality except in lg made kenmore is gone in the other 2 kenmore products made by 2 other manufacturers.

This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is down. Pausing the wash cycle is how it can be disabled. If the door lock is defective the washer door will not latch properly. Close the washer lid before starting the washer.

When lit the lid is locked and cannot be opened without pausing the cycle. Most washing machines come equipped with a lid switch. Your maytag bravos top loading washing machine comes equipped with a lid lock that locks the washing machine lid in the closed position during the wash cycle. Lid locks are problematic in new kenmore washers as well.

The lid will lock and the machine will enter a pump out mode for 8 minutes. This lock acts as a safety mechanism. If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve.

When the light is off the lid can be opened. The door lock can fail either mechanically or electrically. Some will fill with the lid open but will not advance if the lid remains open. However some washing machines come with a lid lock.

Inspect the door lock for damage. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve. The lid lock is a default feature of your maytag front loading and top loading washer to prevent opening the appliance while the cleaning cycle is in progress. If it does not detect both water supply hoses are turned on the control detects a problem with the water pressure sensor.