My maytag neptune washer door will not open.
Maytag neptune washer door locked shut.
Wait approximately 2 minutes for control to reset.
Pausing the wash cycle is how it can be disabled.
It may take up to five minutes for the washer to stop spinning and draining before the door will unlock.
If the door lock is defective the washer door will not latch properly.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
When the control is locked the cycles cannot be started or changed.
Once under tools tap the control lock icon.
Maytag washer door or lid won t lock.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Nothing else will appear to be happening with the machine during this time.
The door will not immediately unlock while the cycle is running due to a possible high water level in the washer high water temperature tumbling or spinning.
The control lock can also be set while the machine is running to prevent someone from stopping or changing a cycle.
Can you help me get the door to open.
A lock icon appears on the front of the washer s control panel to indicate the lid is locked and also displays the current progress of the cleaning cycle depending on the model of your maytag washer.
Swipe up to unlock.
After 8 minutes the door will unlock.
Run a drain and spin cycle.
When i power it up the machine runs for a few minutes then the d o signal flashes and then a f l flashes and it is making a quick slow buzz sound.
The door lock led light will blink.
Reconnect power to washer plug in.
This is a guide about unlocking the door on a maytag front load washer.
The washer will go into a hold and drain routine for 8 minutes.
The door should unlock after 60 seconds.
The door may immediately unlock.
Once the washer door is closed the washer can begin operating.
The door should unlock after this is complete.
Maytag washer door or lid won t lock.
You will hear the door click when it unlocks.
It must be unlocked to operate or run a cycle.
Press this icon to lock the controls.
During this period you will be able to hear the pump running.
If not call for service.
